U3926 BMW Fault Code

Description:

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value.

Low fuel pressure Damaged BMW FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

U3926 Code Symptoms :

There are currently two main types of cylinder deactivation used today, depending on the type of engine. U3926 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.

Diagnosis And Repairing U3926

U3926 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix U3926 code ?

• 1Camshaft Position Sensor circuit poor electrical connection
• Exhaust tube
• Incorrect Positive Crankcase Ventilation (PCV) hose connection
• Faulty Variable Camshaft Timing (VCT) position solenoid

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.